時(shí)間：2011-09-16 15:17來源：藍(lán)天飛行翻譯 作者：航空 點(diǎn)擊：次
|
(Refer to AIM.) d..Prohibited Area- Airspace designated under 14 CFR Part 73 within which no person may operate an aircraft without the permission of the using agency. (Refer to AIM.) (Refer to En Route Charts.) e..Restricted Area- Airspace designated under 14 CFR Part 73, within which the flight of aircraft, while not wholly prohibited, is subject to restriction. Most restricted areas are designated joint use and IFR/VFR operations in the area may be authorized by the controlling ATC facility when it is not being utilized by the using agency. Restricted areas are depicted on en route charts. Where joint use is authorized, the name of the ATC controlling facility is also shown. (Refer to 14 CFR Part 73.) (Refer to AIM.) f..Warning Area- A warning area is airspace of defined dimensions extending from 3 nautical miles outward from the coast of the United States, that contains activity that may be hazardous to nonparticipating aircraft. The purpose of such warning area is to warn nonparticipating pilots of the potential danger. A warning area may be located over domestic or international waters or both. SPECIAL VFR CONDITIONS-Meteorological conditions that are less than those required for basic VFR flight in Class B, C, D, or E surface areas and in which some aircraft are permitted flight under visual flight rules. (See SPECIAL VFR OPERATIONS.) (Refer to 14 CFR Part 91.) SPECIAL VFR FLIGHT [ICAO]- A VFR flight cleared by air traffic control to operate within Class B, C, D, and E surface areas in metrological conditions below VMC. SPECIAL VFR OPERATIONS- Aircraft operating in accordance with clearances within Class B, C, D, and E surface areas in weather conditions less than the basic VFR weather minima. Such operations must be requested by the pilot and approved by ATC. (See SPECIAL VFR CONDITIONS.) (See ICAO term SPECIAL VFR FLIGHT.) SPEED- (See AIRSPEED.) (See GROUND SPEED.) SPEED ADJUSTMENT- An ATC procedure used to request pilots to adjust aircraft speed to a specific value for the purpose of providing desired spacing. Pilots are expected to maintain a speed of plus or minus 10 knots or 0.02 Mach number of the specified speed. Examples of speed adjustments are: a..“Increase/reduce speed to Mach point (num-ber.)” b..“Increase/reduce speed to (speed in knots)” or “Increase/reduce speed (number of knots) knots.” SPEED BRAKES- Moveable aerodynamic devices on aircraft that reduce airspeed during descent and landing. SPEED SEGMENTS- Portions of the arrival route between the transition point and the vertex along the optimum flight path for which speeds and altitudes are specified. There is one set of arrival speed segments adapted from each transition point to each vertex. Each set may contain up to six segments. SQUAWK (Mode, Code, Function)-Activate specific modes/codes/functions on the aircraft transponder; e.g., “Squawk three/alpha, two one zero five, low.” |
